Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap load-balancing | 612
show ap load-balancing
show ap load balancing
Description
Show the load-balancing information for each AP with load balancing enabled.
Examples
The output of the command in the example below shows details for a single AP enabled with the load-balancing
feature.
The output of this command includes the following information:
Command History
Introduced in ArubaOS 3.0.
Command Information
Column Description
BSS The Basic Service Set (BSS) Identifier for the AP. This is usually the APs MAC address.
ESS The Extended Service Set (ESS) Identifier is the user-defined name of an 802.11 wireless
network.
s/p The controller slot and port used by the AP, in the format <slot>/<port>.
The <slot> number is always 1. The <port> parameter refers to the network interfaces that are
embedded in the front panel of the W-3000 Controller Series Multi-Service Controller. Port
numbers start at 0, from the left-most position.
ip IP address of the AP
phy One of the following 802.11 types
z a
z a-HT (high-throughput)
z g
z g-HT (high-throughput)
chan Channel number for the AP 802.11a/802.11n physical layer. The available channels depend on
the AP’s regulatory domain (country).
cur-cl Current number of clients on the AP.
util (kbps) Current bandwidth utilization, in kbps.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
(host) #show ap load-balancing
Load Balance Enabled Access Point Table
---------------------------------------
bss ess name s/p ip phy chan cur-cl util(kbps)
--- --- ---- --- -- --- ---- ------ ----------
00:0b:86:cc:8e:4e Wireless_1 mp22 2/24 10.3.148.12 a-HT 413 3 14