Reference Guide

645 | show ap monitor debug Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Country Code The AP’s country code. Valid radio channels for your wireless network are based on your
country code. If you change the AP’s country code, the valid channels will be reset to the
defaults for the new country.
ap Number of other APs monitored by this AP.
sta Number of clients and APs seen by this AP.
pap Number of potential APs; APs which have transmitted a beacon, but have not yet been
registered.
psta Number of potential stations; AP has seen a MAC address from the station but hasn’t yet
received traffic from it.
ch Number of channel entries in the channel table.
msg-hash Number of different message types seen on the interface.
ap-l (For internal use only)
WMS on Master Indicates if the AP communicates to the wms process on a master or local controller.
enabled: Communicates with a master controller.
disabled: Communicates with a local controller only.
Stats Update Interval If the AP is collecting statistics, this value is the interval in seconds in which the AP sends
statistics to the WMS process on a controller.
Poll Interval Interval, in milliseconds, that the AP sends RSSI updates to the WMS process on a controller.
Num Switches Number of controllers to which this AP has access. If the value is 1, the AP has access to a
master or a local controller. If the value is 2, the AP has access to a master and a local
controller.
Collect Stats If enabled, the AP will collect statistics to send the WMS process on its controller.
Bssid BSSID of the radio.
Type Indicates whether the controller type is master or local.
Status If up, the AP can reach the controller. If down, the AP cannot reach the controller.
Last-reg The time the AP last registered with the WMS process.
N-reg Number of times the AP has registered with the WMS process.
Last-update The last timer tick time the AP updated the WMS process.
Next-update Interval between the last update and the next scheduled update.
N-updates Number of updates sent to the WMS process.
Last-ack Number of timer ticks since the AP received an acknowledgement from the WMS process.
Type Type of RTLS server used by the AP, such as MMS or Aeroscout.
Server IP IP address of the RTLS server.
Port Port used by the RTLS server.
Frequency Rate, in seconds, at which RTLS messages are sent to the server.
Active Indicates if the server is active on the AP.
Column Description