Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap monitor stats | 648
Syntax
Example
The output of the following command shows monitoring statistics for the AP al12, and a client with the MAC
address 00:03:2a:02:6a:d7.
Parameter Description
advanced Show advanced statistics for an AP or client.
ap-name <ap-name> Show statistics for an AP with a specific name.
bssid <bssid> Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic Service
Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr> Show data for an AP with a specific IP address by entering its IP address in dotted-
decimal format.
mac <mac> Show data for a specific MAC address by entering the MAC address of a client or AP.
client-mac <client-mac> Show data for a specific client MAC address by entering the MAC address of a client.
(host) #show ap monitor stats ap-name al12 mac 00:03:2a:02:6a:d7
Aggregate Stats
---------------
retry low-speed non-unicast recv-error frag bwidth
----- --------- ----------- ---------- ---- ------
0 0 0 0 0 0
RSSI
----
avg-signal low-signal high-signal count duration (sec)
---------- ---------- ----------- ----- --------------
51 51 51 4 50
Monitored Time:6626
Last Packet Time:585500
Uptime:585502
DoS Frames
----------
tx old-tx rx old-rx
-- ------ -- ------
0 0 0 0
Interference Baseline
---------------------
FRR FRER
--- ----
17 4
Handoff Assist
--------------
rssi-index cur-signal old-cur-signal
---------- ---------- --------------
0 51 0
High Throughput Parameters
--------------------------
ht-type primary-channel sec-channel gf-supported 40mhz-intolerance
------- --------------- ----------- ------------ -----------------
none 0 0 0 0