Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap spectrum debug status | 684
show ap spectrum debug status
show ap spectrum debug status {ap-name <ap-name>}|{ip-addr <ip-addr>} freq-band
2.4ghz|5ghz
Description
This command shows detailed status and statistics for a spectrum monitor.
Syntax
Usage Guidelines
Use this command under the guidance of an Dell technical support representative to troubleshoot spectrum
analysis errors.
Related Commands
Command History
Introduced in ArubaOS 6.0.
Command Information
Parameter Description
ap-name <ap-name> Name of the spectrum monitor for which you want to view status information.
ip-addr <ip-addr> IP address of the spectrum monitor for which you want to view status information.
freq-band 2.4ghz|5ghz View information for a specific radio type, either 2.4 GHz or 5 GHz.
Command Description Mode
ap spectrum local-override Convert an AP or AM into a spectrum monitor
by adding it to the spectrum local-override list.
Config mode on master or local
controllers
rf dot11a-radio-profile
mode spectrum-mode
Set a 802.11a radio so the device operates as
an spectrum monitor, and can send spectrum
analysis data to a desktop or laptop client.
Config mode on master or local
controllers
rf dot11g-radio-profile
mode spectrum-mode
Set a 802.11g radio so the device operates as
an spectrum monitor, and can send spectrum
analysis data to a desktop or laptop client.
Config mode on master or local
controllers
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or local
controllers