Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show crypto dp | 742
show crypto dp
show
show crypto dp [peer <source-ip>]
Descriptions
Displays crypto data packets.
Syntax
Usage Guidelines
Use this command to send crypto data packet information to the controller log files, or to clear a crypto ISAKMP
state associated with a specific IP address.
Examples
The command show crypto dp sends debug information to CRYTPO logs.
Related Commands
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Parameter Description
dp Shows crypto latest datapath packets. The output is sent to crypto logs.
peer <source-ip> Clears crypto ISAKMP state for this IP.
Command Description Mode
crypto isakmp Use this command to configure Internet Key Exchange
(IKE) parameters for the Internet Security Association and
Key Management Protocol (ISAKMP)
Enable and Config modes
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or local
controllers
(host) # show crypto
Datapath debug output sent to CRYPTO logs.