Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show interface loopback | 830
show interface loopback
show interface loopback
Description
Displays information about the loopback IP interface.
Syntax
No parameters
Example
The example below shows the output of show interface loopback on a W-600 Series Controller controller.
The output of this command includes the following parameters:
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Parameter Description
loopback interface
is...
Status of the loopback interface.
line protocol is... Status of the line protocol on the specified port.
Hardware is... Hardware interface type.
address is... MAC address of the loopback interface.
Internet address
is...
IP address and subnet mask of the loopback interface.
Platforms Licensing Command Mode
All platforms Base operating system Enable or config mode on master controllers
#show interface loopback
loopback interface is up line protocol is up
Hardware is Ethernet, address is 00:0B:86:51:14:D0
Internet address is 10.3.49.100 255.255.255.255