Reference Guide

Table Of Contents
831 |show interface port-channel Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show interface port-channel
show interface port-channel
Description
Displays information about a specified port-channel interface.
Syntax
Example
The example below shows the output of show interface port-channel 0 on a controller.
The output of this command includes the following parameters:
Parameter Description
access-group Displays access groups configured on this interface.
counters Displays L2 interface counters for the specified interface.
untrusted-vlan Displays port member vlan untrusted status.
xsec Displays xsec configuration.
Parameter Description
Port-Channel 0 is... Status of the specified port.
line protocol is... Status of the line protocol on the specified port.
Hardware is.... Hardware interface type.
address is... MAC address of the hardware interface.
Description The port type, name, and connector type. If the LAG is created by LACP, it is indicated as
shown in the display output above. If the LAG is created by LACP, you can not statically add or
delete any ports under that port channel. All other commands are allowed. If LACP is not
shown, then the LAG is created by static configuration.
Spanning Tree is... Spanning tree status on the specified port-channel.
VLAN membership Number of VLANs the specified port-channel is associated with.
Switchport priority Switchport priority of the specified port-channel.
Port-Channel 0 is administratively up
Hardware is Port-Channel, address is 00:00:00:00:00:00 (bia 00:0B:86:F0:36:B1)
Description: Link Aggregate (LACP)
Spanning Tree is disabled
VLAN membership: 1
Switchport priority: 0
Member port:
Last clearing of "show interface" counters 3 day 21 hr 23 min 6 sec
link status last changed 3 day 21 hr 23 min 6 sec
0 packets input, 0 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
0 multicast, 0 unicast