Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ip nat pool | 856
show ip nat pool
show ip nat pool
Description
Display pools of IP addresses for network address translation (NAT.
Syntax
No parameters
Examples
The example below shows the current NAT pool configuration on the controller.
The output of this command includes the following parameters:
Related Commands
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
Name Name of the NAT pool.
Start IP IP address that defines the beginning of the range of source NAT addresses in the pool.
End IP IP address that defines the end of the range of source NAT addresses in the pool.
DNAT IP Destination NAT IP address, if defined.
Command Description
ip nat This command configures a pool of IP addresses for network address translation (NAT).
Platforms Licensing Command Mode
All platforms Though this command is available in the operating system, you must
have a PEFNG license to configure a NAT pool.
Available in Config or Enable mode
on master or local controllers
(host) # show ip nat pools
NAT Pools
---------
Name Start IP End IP DNAT IP
---- -------- --------- -------
2net 2.1.1.1 2.1.1.125