Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ip pppoe-info | 860
show ip pppoe-info
show ip pppoe-info
Description
Display configuration settings for Point-to-Point Protocol over Ethernet (PPPoE).
Syntax
No parameters.
Examples
The example below shows the current PPPoE configuration.
The output of this command includes the following parameters:
Related Commands
Command History
Introduced in ArubaOS 3.0.
Command Information
Parameter Description
PPPoE username PAP username configured on the PPPoE access concentrator.
PPPoE password If this parameter displays the word <HIDDEN>, a PAP password is configured on the PPPoE access
concentrator. If this parameter is <NONE>, there is no PPOE password configured.
PPPoE service name PPPoE service name.
PPPoE VLAN VLAN configured to use PPPoE to obtain an IP address via the command interface vlan <id> ip
address pppoe.
Command Description
ip pppoe-password This command configures the PPP over Ethernet (PPPoE) password.
ip pppoe-service-name This command configures the PPP over Ethernet (PPPoE) service name.
ip pppoe-username This command configures the PPP over Ethernet (PPPoE) username.
Platforms Licensing Command Mode
All platforms Base operating system Available in Config or Enable mode on master or
local controllers
(host) #show ip pppoe-info
PPPoE username: rudolph123
PPPoE password: <HIDDEN>
PPPoE service name: ppp2056
PPPoE VLAN: 22