Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ip route | 862
show ip route
show ip route [static]
Description
View the Dell controller routing table.
Syntax
Usage Guidelines
This command displays static routes configured on the controller via the ip route command. Use the ip default-
gateway command to set the default gateway to the IP address of the interface on the upstream router or switch
to which you connect the controller.
Examples
The example below shows the ip address of routers and the VLANs to which they are connected.
Related Commands
Command History
Introduced in ArubaOS 3.0.
Command Information
Command Description
static Include this optional parameter to display only static routes.
Command Description
ip radius This command configures global parameters for configured RADIUS servers.
Platforms Licensing Command Mode
All platforms Base operating system Available in Config or Enable mode on master or
local controllers
(host) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
Gateway of last resort is 10.6.2.254 to network 0.0.0.0
S* 0.0.0.0/0 [1/0] via 10.6.2.254*
C 10.9.2.0 is directly connected, VLAN1
C 10.9.3.0 is directly connected, VLAN63
C 10.9.4.0 is directly connected, VLAN64
C 10.9.5.0 is directly connected, VLAN65
C 10.9.6.0 is directly connected, VLAN66
C 0.0.0.0 is directly connected, Tunnel 1
C 10.100.103.253 is an ipsec map default-local-master-ipsecmap