Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show remote-node-dhcp-pool | 984
show remote-node-dhcp-pool
show remote-node-dhcp-pool <remote-node-profile-name>
Description
The output of this command lists shows Remote Node DHCP pool summary information.
Syntax
Usage Guidelines
Each Remote Node profile contains a Remote Node DHCP address pool, which defines a range of IP addresses
allocated for Remote Node controllers at a remote site, and the VLAN to be associated with those addresses. A
remote-node dhcp pool is configured in the remote-note mode.
Use the show remote-node-dhcp-pool command to view a summary of Remote Node address pool information.
Example
This example shows a summary of Remote Node DHCP address pool information.
The output of this command includes the following parameters:
Parameter Description
remote-node-profile-
name
Name of the Remote Node profile
Parameter Description
Pool Name Name of the new DHCP pool.
Type Type of pool. This can be tunnel or vlan.
Start IP Address IP addresses at the start and end of the Remote Node’s address range, in dotted-decimal
format.
End IP Address IP address at the end of the Remote Node’s address range, in dotted-decimal format.
Domain Name The DHCP domain name.
Num Hosts Maximum number of hosts supported by a Remote Node using this pool.
(host) #show remote-node-dhcp-pool pool1
Remote Node Address Pools
--------------------------------------
Pool Name Type Start IP Address End IP Address Domain Name Num Hosts
--------- ---- ---------------- -------------- ----------- ---------