Users Guide

456 | Adding Local Controllers Dell PowerConnect W-Series ArubaOS 6.1 | User Guide
4. For those APs that need to boot off the local controller, configure the LMS IP address to point to the new
local controller.
5. Reboot the APs that are already on the network, so that they now connect to the local controller.
These steps are explained below.
Configuring the Local Controller
You configure the role of a controller by running the initial setup on an unconfigured controller, or by using the
WebUI, Controller Wizard, or CLI on a previously-configured controller.
Using the Initial Setup
Initial setup can be done using the browser-based Setup Wizard or by accessing the initial setup dialog via a serial
port connection. Both methods are described in the Dell PowerConnect W-Series ArubaOS Quick Start Guide and
are referred to throughout this chapter as “initial setup.”
The initial setup allows you to configure the IP address of the controller and its role, in addition to other
operating parameters. You perform the initial setup the first time you connect to and log into the controller or
whenever the controller is reset to its factory default configuration (after executing a write erase, reload
sequence).
When prompted to enter the controller role in the initial setup, select or enter local to set the controller
operational mode to be a local controller. You are then prompted for the master controller IP address. Enter the
IP address of the master controller for the WLAN network. Enter the preshared key (PSK) that is used to
authenticate communications between controllers.
Using the Web UI
For a controller that is up and operating with layer-3 connectivity, configure the following to set the controller as
local:
1. Navigate to the Configuration > Network > Controller > System Settings page.
2. Set the Controller Role to Local.
3. Enter the IP address of the master controller. If master redundancy is enabled on the master, this address
should be the VRRP address for the VLAN instance corresponding to the IP address of the controller.
4. Enter the preshared key (PSK) that is used to authenticate communications between controllers.
Using the CLI
For a controller that is up and operating with layer-3 connectivity, configure the following to set the controller as
local:
masterip <ipaddr> ipsec <key>
Configuring Layer-2/Layer-3 Settings
Configure the VLANs, subnets, and IP address on the local controller for IP connectivity.
Verify connectivity to the master controller by pinging the master controller from the local controller.
NOTE: You need to enter the same PSK on the master controller and on the local controllers that are managed by the master.
NOTE: You need to enter the same PSK on the master controller and on the local controllers that are managed by the master.