Users Guide

Dell PowerConnect W-Series ArubaOS 6.1 | User Guide The Basic User-Centric Networks | 55
(host) #configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(host) (config) #vlan-name mygroup pool
(host) (config) #vlan mygroup 2,4,12
(host) (config) #
To confirm the VLAN pool status and mappings assignments, use the show vlan mapping command:
(host) (config) #show vlan mapping
VLAN Name Pool Status VLAN IDs
--------- ----------- --------
mygroup Enabled 2,4,12
group123 Disabled
Assigning and Configuring the Trunk Port
The following procedures configures a Gigabit Ethernet port as trunk port.
In the WebUI
1. Navigate to the Configuration > Network > Ports window on the WebUI.
2. In the Port Selection section, click the port that will connect the controller to the network. In this example,
click port 25.
3. For Port Mode, select Trunk.
4. For Native VLAN, select VLAN 5 from the scrolling list, then click the left (<--) arrow.
5. Click Apply.
In the CLI
interface gigabitethernet 1/25
switchport mode trunk
switchport trunk native vlan 5
To confirm the port assignments, use the show vlan command:
(host) (config) #show vlan
VLAN CONFIGURATION
------------------
VLAN Name Ports
---- ---- -----
1 Default Fa1/0-23 Gig1/24
5 VLAN0005 Gig1/25
Configuring the Default Gateway
The following configurations assign a default gateway for the controller.
In the WebUI
1. Navigate to the Configuration > Network > IP > IP Routes window.
2. To add a new static gateway, click the Add button below the static IP address list.
a. In the IP Address field, enter an IP address in dotted-decimal format.
b. In the Cost field, enter a value for the path cost.
c. Click Add.
3. You can define a dynamic gateway using DHCP, PPPOE or a cell uplink interface. In the Dynamic section,
click the DHCP, PPPoE or Cellular checkboxes to select one or more dynamic gateway options. If you select
more than one dynamic gateway type, you must also define a cost for the route to each gateway. The
controller will first attempt to obtain a gateway IP address using the option with the lowest cost. If the