Reference Guide

Table Of Contents
1024 | show ntp peer Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
show ntp peer
show ntp peer <a.b.c.d>
Description
Show NTP peer information.
Syntax
Usage guidelines
The show ntp peer command is used for NTP server troubleshooting, and should only be used under the
supervision of Dell technical support. Issue the show ntp servers command to view basic settings for currently
configured NTP servers.
Related Commands
To configure an NTP server, use the command ntp server.
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
<a.b.c.d> IP address of an NTP peer
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers