Reference Guide

1092 | show rf dot11g-radio-profile Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
This example displays the configuration settings for the profile airwave.
The output of this command includes the following parameters:
Parameter Description
Radio enable Shows if the AP has enabled or disabled transmissions on this radio band.
Mode Access Point operating mode. Available options are:
 am-mode: Air Monitor mode
 ap-mode: Access Point mode
 apm-mode: Access Point Monitor mode
 sensor-mode: RFprotect sensor mode
High throughput enable (radio) Name of a high-throughput profile referenced by this 802.11a radio profile.
A high-throughput profile manages 40 Mhz tolerance settings, and controls whether or not
APs using this profile will advertise intolerance of 40 MHz operation. (This option is
disabled by default, allowing 40 MHz operation.)
A high-throughput profile also determines whether an AP radio using the profile will stop
using the 40 MHz channels surrounding APs or stations advertise 40 Mhz intolerance. This
option is enabled by default.
Channel Channel number for the AP 802.11a/802.11n physical layer.
Beacon Period Time, in milliseconds, between successive beacon transmissions. The beacon advertises
the AP’s presence, identity, and radio characteristics to wireless clients.
Beacon Regulate If enabled, this option introduces randomness in the beacon generation so that multiple
APs on the same channel do not send beacons at the same time, which causes collisions
over the air. This option is disabled by default.
Transmit EIRP Maximum transmit power (EIRP) in dBm from 0 to 51 in .5 dBm increments. Further limited
by regulatory domain constraints and AP capabilities.
(host) # show rf dot11g-radio-profile default
Parameter Value
--------- -----
Radio enable Enabled
Mode ap-mode
High throughput enable (radio) Enabled
Channel N/A
Beacon Period 100 msec
Beacon Regulate Disabled
Transmit EIRP 15 dBm
Advertise 802.11d and 802.11h Capabilities Disabled
TPC Power 15 dBm
Spectrum load balancing Disabled
Spectrum Load balancing mode channel
Spectrum load balancing update interval (sec) 30 seconds
Advertised regulatory max EIRP 0
Spectrum Load Balancing domain N/A
RX Sensitivity Tuning Based Channel Reuse disable
RX Sensitivity Threshold 0 -dBm
Non 802.11 Interference Immunity Level-2
Enable CSA Disabled
CSA Count 4
Management Frame Throttle interval 1 sec
Management Frame Throttle Limit 20
ARM/WIDS Override Disabled
Protection for 802.11b Clients Enabled
Adaptive Radio Management (ARM) Profile default
High-throughput Radio Profile default-g
Maximum Distance 0 meters
Spectrum Monitoring Disabled
Spectrum Monitoring Profile default-a
AM Scanning Profile default