Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show wms probe | 1225
show wms probe
show wms probe
Description
Display detailed information for a list of WMS probes.
Syntax
No parameters.
Example
This example shows the Probe List table for WMS probes. The output below has been split into two tables to
better fit in this document. In the actual command-line interface, this information appears in a single, long table.
The output of this command includes the following information:
Column Description
Monitor Eth MAC Ethernet MAC address of a probe.
BSSID Probe Radio BSSID.
PHY Type Radio PHY type:
 802.11A
 802.11AHT-40Mbps
 802.11AHT-20Mbps
 802.11G
 802,11GHT-20Mbps
IP IP address of the AP.
LMS IP IP address of the AP’s local controller.
Scan Shows if the Air Monitor is performing scanning.
Status If the scan column displays a status of Up, the AP or AM is active
Updates Number of updates the AP or AM sent to the WMS database since the controller was last reset.
Reqs/Fails Number of database update requests that have not yet been added into the database. and the
number of failed database requests.
Stats Total number of statistics updates sent to the database.
Type A WMS AP type can be one of the following:
 soft-ap: an Dell Access Point (AP).
 air-monitor: An Dell Air Monitor (AM).
(host) #show wms probe
Probe List
----------
Monitor Eth MAC BSSID PHY Type IP LMS IP
--------------- ----- -------- -- ------
00:0b:86:64:a9:a0 00:1a:1e:50:44:90 80211GHT-20mhz 10.4.62.11 10.4.62.11
Scan Status Updates Reqs/Fails Stats Type
---- ------ ------- ---------- ----- ----
No Up 20731 1/0 0 soft-ap