Reference Guide

1272 | user-role Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Usage Guidelines
Every client in a user-centric network is associated with a user role. All wireless clients start in an initial role. From
the initial role, clients can be placed into other user roles as they pass authentication.
Example
The following command configures a user role:
(host) (config) #user-role new-user
dialer default-dialer
pool pptp-pool-1
Command History
Command Information
vlan
Identifies the VLAN ID or VLAN name to which the user role is mapped. This
parameters works only when using Layer-2 authentication such as 802.1x or
MAC address, ESSID, or encryption type role mapping because these
authentications occur before an IP address is assigned. If a user
authenticates using a Layer-3 mechanism such as VPN or captive portal this
parameter has no effect.
NOTE: VLAN IDs and VLAN names cannot be listed together.
——
wispr Apply WISPr authentication to the specified user role.
Version Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.4.1 The stateful-ntlm and wispr parameters were introduced.
ArubaOS 6.1 The ipv6 session-acl parameter was removed. The session-acl parameter is common for
both IPv4 and IPv6 ACLs.
Platforms Licensing Command Mode
All platforms This command requires the PEFNG
license.
Config mode on master controllers
Parameter Description Range Default