Reference Guide

1324 | wlan ssid-profile Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
g-basic-rates List of supported 802.11b/g rates that are advertised in beacon frames and
probe responses.
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54 Mbps
1, 2 Mbps
g-beacon-rate Sets the beacon rate for 802.11g (use for Distributed Antenna System
(DAS) only). Using this parameter in normal operation may cause
connectivity problems.
default,
1,2,5, 6 9,
11, 12, 18,
24, 36, 48,
54 Mbps
minimum
valid rate
g-tx-rates Set of 802.11b/g rates at which the AP is allowed to send data. The actual
transmit rate depends on what the client is able to handle, based on
information sent at the time of association and on the current error/loss
rate of the client.
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54 Mbps
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54 Mbps
hide-ssid Enables or disables hiding of the SSID name in beacon frames. Note that
hiding the SSID does very little to increase security.
— disabled
ht-ssid-profile Name of high-throughput SSID profile to use for configuring high-
throughput support. See “wlan ht-ssid-profile” on page 1318.
— “default”
local-probe-req-
thresh
APs will not respond to client probe requests if the SNR value in the probe
request is less than the specified threshold value.
0-100 0
max-clients Maximum number of wireless clients for the AP. 0-256 64
max-retries Maximum number of retries allowed for the AP to send a frame. 0-15 4
max-tx-fail Maximum transmission failures allowed before the client gives up. 0
mcast-rate-opt Enables or disables scanning of all active stations currently associated to
an AP to select the lowest transmission rate for broadcast and multicast
frames. This option only applies to broadcast and multicast data frames;
802.11 management frames are transmitted at the lowest configured rate.
NOTE: Do not enable this parameter unless instructed to do so by your
Dell technical support representative.
— disabled
no Negates any configured parameter. — —
opmode The layer-2 authentication and encryption to be used on this ESSID to
protect access and ensure the privacy of the data transmitted to and from
the network.
(see
following)
opensyste
m
dynamic-wep WEP with dynamic keys.
opensystem No authentication and encryption.
static-wep WEP with static keys.
wpa-aes WPA with AES encryption and dynamic keys using 802.1x.
wpa2-aes-gcm-
128
WPA2 with AES GCM-128 (Suite-b) encryption and dynamic keys
using 802.1X. This parameter requires the ACR license.
wpa2-aes-gcm-
256
WPA2 with AES GCM-256 (Suite-b) encryption and dynamic keys
using 802.1X. This parameter requires the ACR license.
wpa-psk-aes WPA with AES encryption using a preshared key.
wpa-psk-tkip WPA with TKIP encryption using a preshared key.
wpa-tkip WPA with TKIP encryption and dynamic keys using 802.1x.
wpa2-aes WPA2 with AES encryption and dynamic keys using 802.1x.
wpa2-psk-aes WPA2 with AES encryption using a preshared key.
Parameter Description Range Default