Reference Guide

Table Of Contents
176 | controller-ipv6 Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
controller-ipv6
controller-ipv6 [loopback|vlan <VLAN ID>]
no ...
Description
This command sets the default IPv6 address of the controller to the IPv6 loopback interface address or a specific
VLAN interface address.
Syntax
Usage Guidelines
This command allows you to set the default IPv6 address of the controller to the IPv6 loopback interface address
or a specific IPv6 VLAN interface address. If the controller IPv6 command is not configured then the controller IP
defaults to the loopback interface address. If the loopback interface address is not configured then the first
configured VLAN interface address is selected. Generally, VLAN 1 is the factory default setting and thus becomes
the controller IP address.
Example
The following command sets the controller IP address to VLAN interface 6.
(host) (config) #controller-ipv6 vlan 6
Related Commands
(host) (config) #show controller-ipv6
Command History
This command is introduced in ArubaOS 6.1.
Command Information
Parameter Description Default
loopback Sets the controller IP to the loopback interface. disabled
vlan Set thecontroller IP to a VLAN interface.
VLAN ID Specifies the VLAN interface ID.
Platform License Command Mode
Available on all platforms Base operating system Config mode on master controllers