Reference Guide

282 | interface fastethernet | gigabitethernet Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Usage Guidelines
Use the show port status command to obtain information about the interfaces available on the controller.
Example
The following commands configure an interface as a trunk port for a set of VLANs:
(host) (config) # interface fastethernet 1/2
(host) (config-range)# switchport mode trunk
(host) (config-range)# switchport trunk native vlan 10
(host) (config-range)# switchport trunk allowed vlan 1,10,100
The following commands configure trunk port 1/2 with test-acl session for VLAN 2.
(host) (config) # interface range fastethernet 1/2
(host) (config-range)# switchport mode trunk
(host) (config-range)# ip access-group
(host) (config-range) # ip access-group test session vlan 2
Related Commands
(host) #show interface {fastethernet|gigabitethernet} <slot>/<port>
(host) #show datapath port vlan-table <slot>/<port>
Command History
Command Information
point-to-point MAC address of the controller that is the xSec tunnel
termination point, and the 16-byte shared key used to
authenticate the controllers to each other. The key must be the
same on both controllers.
——
allowed vlan VLANs that are allowed on the xSec tunnel. — —
mtu (Optional) MTU size for the xSec tunnel. — —
vlan xSec VLAN ID. For controller-to-controller communications,
both controllers must belong to the same VLAN.
1-4094 —
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.4 The trusted VLAN and ip access-group session vlan parameters were introduced.
ArubaOS 3.4.1 The trusted vlan <word> parameter was added.
ArubaOS 6.1 The parameter muxport was changed to tunneled-node-port
Platforms Licensing Command Mode
All platforms This command is available in the base
operating system. The ip access-group
parameter requires the PEFNG license.
The xsec parameter requires the xSec
license.
Config mode on master and local controllers
Parameter Description Range Default