Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide provision-ap | 435
g-ant-tilt-angle Directs the angle of the 802.11g (2.4GHz) antenna for
optimum coverage.
Use a - (negative) value for downtilt and a + (positive) value
for uptilt.
NOTE: This parameter is supported on outdoor APs only. If
you use this parameter to configure an indoor AP, an error
message is displayed.
-90 to +90
Decimal Degrees
—
g-antenna Antenna use for 2.4 GHz (802.11g) frequency band.
 1: Use antenna 1
 2: Use antenna 2
 both: Use both antennas
1, 2, both both
gateway IP address of the default gateway for the AP. — —
gateway6 IPv6 address of the default gateway for the AP. — —
ikepsk IKE preshared key for the AP. — —
installation Specify the type of installation (indoor or outdoor). The
default parameter automatically selects an installation
mode based upon the AP model type.
default
indoor
outdoor
default
ip6addr Static IPv6 address of the AP. — —
ip6prefix The prefix of static IPv6 address of the AP. — —
ipaddr Static IP address for the AP. — —
latitude Latitude coordinates of the AP. Use the format: Degrees,
Minutes, Seconds (DMS). For example: 37 22 00 N
——
longitude Longitude coordinates of the AP. Use the DMS format. For
example: 122 02 00 W
——
master Name or IP address of the master controller. — —
mesh-role Configure the AP to operate as a mesh node. You assign
one of three roles: mesh portal, mesh point or remote mesh
point. If you select “none,” the AP operates as a thin AP.
mesh-portal
mesh-point
remote-mesh-
portal
none
—
mesh-sae Enable or disable Simultaneous Authentication of Equals
(SAE) on a mesh network. This option offers enhanced
security over the default wpa2-psk-aes mesh security
setting, and provides secure, attack-resistant
authentication using a pre-shared key. SAE supports
simultaneous initiation of a key exchange, allowing either
party to initiate an exchange or both parties to initiate a key
exchange simultaneously
To use the SAE feature, you must enable this parameter on
all mesh nodes (points and portals) in the network, to
prevent mesh link connectivity issues.
NOTE: This is a Beta feature only. This parameter should be
kept “disabled” for this release.
sae-disable
sae-enable
sae-disable
netmask Netmask for the IP address. — —
no Negates any configured parameter. — —
Parameter Description Range Default