Reference Guide

454 | remote-node-profile Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Syntax
Parameter Description
aaa Configure authentication server using an internal server. For details, see
“aaa authentication-server internal” on page 45
cellular profile <name> Cellular interface profile associated with this Remote Node profile. For
details, see “cellular profile” on page 153.
clone <profile-name> Use this command to copy a Remote Node profile to this profile.
controller-ip vlan <id> ip address Select one of the following parameters for the VLAN interface
dhcp-client: The remote node will use DHCP to obtain IP address
internal: Then remote node IP is derived from the remote node DHCP
pool.
pppoe: Use PPPoE to obtain IP address
dialer group <name> Dialer group profile associated with this Remote Node profile.
instance Configure the Remote Node MAC address to associate the Remote Node
to this profile. When you create a new Remote Node profile, enter the
remote-node profile instance command first.
interface Configure the Remote Node interface
 cellular—Configure the cellular Interface.
 fastethernet—Configure the FastEthernet (IEEE 802.3) interface.
 gigabitethernet—Configure the GigabitEthernet Interface.
 loopback—Configure the Loopback Interface.
 port-channel—Configure the Ethernet channel of interfaces.
 tunnel—Configure the Tunnel interface.
 vlan —Configure the Switch VLAN Virtual Interface.
NOTE: The VLAN ID mapped using the “interface vlan <id> ip address”
command can use the following parameters to define how the controller-
ip is derived:
 dhcp-client: The remote node will use DHCP to obtain IP address
 internal: Then remote node IP is derived from the remote node DHCP
pool.
 pppoe: Use PPPoE to obtain IP address
 For details on using this command,
see “interface fastethernet | gigabitethernet” on page 280
ip Configure the Interface Internet Protocol configuration sub commands.
For details, see command descriptions beginning with ip default-
gateway on page 308.
 default-gateway
 domain lookup
 domain-name
 name-server
 nat
 radius
 route
ipv6 Configure the Global IPv6 configuration sub commands. For details, see
command descriptions beginning with ipv6 enable on page 340.
 enable
 route X:X:X:X::X/<0-128>