Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide remote-node-profile | 455
logging Set the logging level up to which messages are logged.
 A.B.C.D
 facility
 level
For details on using this command, see “logging” on page 379
mgmt-server Register Mgmt Server IP Address with the controller.This could be
AirWave Management Server or any other server that would like to
receive messages from the controller using AMON protocol. For details
on using this command, see mgmt-server on page 394.
mgmt-user Configure a management user. For details on using this command, see
“mgmt-user” on page 395.
mobility-manager Configure a mobility manager. For details on using command, see
mobility-manager on page 13.
model <model_type> Controller model associated to the Remote Node profile, where <model-
type> is one of the following controller model types:
 W-3200
 W-3400
 W-3600
 620
 650
 651
no Delete a remote node profile.
priority-map <name> Priority Map specification, used to prioritize the incoming packets on an
interface. For details on using this command, see “priority-map” on
page 428.
remote-node-dhcp-pool <pool_name> Name of the DHCP pool.
pool-type {vlan <id>}|tunnel Specify whether you are creating a pool of IP addresses for RN VLANs or
RN tunnels.
<id> The ID number of the VLAN associated with the RN.
<start-ip> IP addresses at the start and end of the RN’s address range, in dotted-
decimal format.
<end-ip> IP address at the end of the RN’s address range, in dotted-decimal
format.
num_hosts Maximum number of hosts supported by an RN using this pool.
router ospf <area-id> Enables and configures OSPF. Configure an OSP area, control
distribution of default information, redistribute the route, configure the
Router ID and specific the subnet.
snmp-server Enables SNMP and modifies SNMP parameters. For details on using this
command, see snmp-server on page 1239.
spanning-tree Create a Spanning Tree Subsystem. For details on using this command,
see “spanning-tree (Global Configuration)” on page 1242.
syscontact <syscontact> Configures the name of the system contact for the controller. Enter an
alphanumeric string that specifies the name of the system contact.
syslocation <syslocation> Configures the name of the system location for the controller. Enter an
alphanumeric string that specifies the name of the system location.
uplink Define an uplink manager configuration. For details on using this
command, see “uplink” on page 1267.
Parameter Description