Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide rf event-thresholds-profile | 479
rf event-thresholds-profile
rf event-thresholds-profile <profile>
bwr-high-wm <percent>
bwr-low-wm <percent>
clone <profile>
detect-frame-rate-anomalies
fer-high-wm <percent>
fer-low-wm <percent>
ffr-high-wm <percent>
ffr-low-wm <percent>
flsr-high-wm <percent>
flsr-low-wm <percent>
fnur-high-wm <percent>
fnur-low-wm <percent>
frer-high-wm <percent>
frer-low-wm <percent>
frr-high-wm <percent>
frr-low-wm <percent>
no ...
Description
This command configures the event thresholds profile.
Syntax
This command includes the following configuration parameters.
Parameter Description Range Default
<profile> Name of this instance of the profile. The name must be 1-
63 characters.
— “default”
bwr-high-wm If bandwidth in an AP exceeds this value, a bandwidth
exceeded condition exists. The value represents the
percentage of maximum for a given radio. (For 802.11b, the
maximum bandwidth is 7 Mbps. For 802.11 a and g, the
maximum is 30 Mbps.) The recommended value is 85%.
0-100 0%
bwr-low-wm After a bandwidth exceeded condition exists, the
condition persists until bandwidth drops below this value.
The recommended value is 70%.
0-100 0%
clone Name of an existing radio profile from which parameter
values are copied.
——
detect-frame-
rate-anomalies
Enable or disables detection of frame rate anomalies. — disabled
fer-high-wm If the frame error rate (as a percentage of total frames in
an AP) exceeds this value, a frame error rate exceeded
condition exists. The recommended value is 16%.
0-100 0%
fer-low-wm After a frame error rate exceeded condition exists, the
condition persists until the frame error rate drops below
this value. The recommended value is 8%.
0-100 0%
ffr-high-wm If the frame fragmentation rate (as a percentage of total
frames in an AP) exceeds this value, a frame
fragmentation rate exceeded condition exists. The
recommended value is 16%.
0-100 16%