Reference Guide

580 | show acl hits Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
The output of this command includes the following information:
Command History
This command was available in ArubaOS 3.0.
Parameter Description
Role Name of the role assigned by the ACL.
Policy Name of the policy used by the ACL
Src The traffic source, which can be one of the following:
 <alias>: Name of a user-defined alias for a network host, subnetwork, or range of
addresses.
 any: match any traffic.
 host: specify a single host IP address.
 network: specify the IP address and netmask.
 user: represents the IP address of the user.
Dst The traffic destination, which can be one of the following:
 <alias>: Name of a user-defined alias for a network host, subnetwork, or range of
addresses.
 any: match any traffic.
 host: specify a single host IP address.
 network: specify the IP address and netmask.
 user: represents the IP address of the user.
Service Network service, which can be one of the following:
 IP protocol number (0-255)
 name of a network service (use the show netservice command to see configured
services)
 any: match any traffic
 tcp: specify the TCP port number (0-65535)
 udp: specify the UDP port number (0-65535)
Action Action if rule is applied, which can be one of the following:
 deny: reject packets
 dst-nat: perform destination NAT on packets
 dual-nat: perform both source and destination NAT on packets
 permit: forward packets
 redirect: specify the location to which packets are redirected
 src-nat: perform source NAT on packets
Dest/Opcode The datapath destination ID.
New Hits Number of ACL hits that occurred since this command was last issued.
Total Hits Total number of ACL hits recorded since the controller last reset.
Index Index number of the ACL.
ACL ACL number
ACE ACE number
New Hits Number of times the ACL was applied since this command was last issued.
Total Hits Number of times the ACL was applied since the controller was last reset.
Index Index number of the ACL.