Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show ap allowed-channels | 587
show ap allowed-channels
show ap allowed-channels [<ap-name>|<country-code>|<ip-addr>]
Description
This command shows configuration information for Captive portal authentication profiles.
Syntax
Usage Guidelines
Specify the country code for your controller during initial setup. Changing the country code causes the valid
channel lists to be reset to the defaults for that country.
Examples
The output of this example shows all allowed channels for the country code US.
Command History
Introduced in ArubaOS 3.0.
Command Information
Parameter Description
<ap-name> Name of an AP.
<country-code> Specify a country code to display allowed channels for that country.
<ip-addr> IP address of an AP, in dotted-decimal format.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
(host)# show ap allowed-channels US
Allowed Channels for Country Code "US"
--------------------------------------
PHY Type Allowed Channels
-------- ----------------
802.11g (indoor) 1 2 3 4 5 6 7 8 9 10 11
802.11a (indoor) 36 40 44 48 149 153 157 161 165
802.11g (outdoor) 1 2 3 4 5 6 7 8 9 10 11
802.11a (outdoor) 149 153 157 161 165
802.11g 40MHz (indoor) 1-5 2-6 3-7 4-8 5-9 6-10 7-11
802.11a 40MHz (indoor) 36-40 44-48 149-153 157-161
802.11g 40MHz (outdoor) 1-5 2-6 3-7 4-8 5-9 6-10 7-11
802.11a 40MHz (outdoor) 149-153 157-161