Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show ap debug system-status | 669
show ap debug system-status
show ap debug system-status {ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>}
Description
Show detailed system status information for an AP.
Syntax
Usage Guidelines
The output of this command displays the following types of information (if it exists) for the selected AP:
The following parameters are included in the output of this command, and can help troubleshoot problems on an
AP or wireless network.
Parameter Description
ap-name <ap-name> Show system status data for an AP with a specific name.
bssid <bssid> Show system status data for a specific Basic Service Set Identifier (BSSID) on an AP. The
Basic Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr> Show system status data for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
 Bootstrap information  Per-radio statistics  Ethernet duplex/speed settings
 Descriptor Usage  Encryption statistics  Tunnel heartbeat stats
 Interface counters  AP uptime  Boot version
 MTU discovery  memory usage  LMS information
 ARP cache  Kernel slab statistics  Power status
 Route table  Interrupts  CPU type
 Interface Information  Crash Information
Parameter Description
The Failed column in the Descriptor Usage
section
This parameter can tell you if the AP is dropping packets.
Interface Information table This parameter can tell you if the ethernet network is working properly. This table
should not show an excessive number of errors.
AP Uptime table Low values in this table can indicate problems with the wired network, or with the
AP itself.
Tunnel Heartbeat table This table can indicate the health of the underlying wired network.
Rebootstrap Information table /Reboot
Information table
A large number of reboots can mean that the AP has hardware problems.