Reference Guide

Table Of Contents
Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show ap mesh active | 687
Command History
Introduced in ArubaOS 3.0.
Command Information
Enet 0/1 Shows the current mode of each wired interface.
Bridge: 802.11 frames are bridged into the local Ethernet LAN.
Tunnel: 802.11 frames are tunneled to the controller using generic routing encapsulation
(GRE).
Split-tunnel: 802.11 frames are either bridged into the local Ethernet LAN or tunneled to the
controller, depending upon their destination.
Off: Interface is not available for serving clients.
If an AP has only one wired interface, the output of this command will display a dash (-) for the
unavailable port.
Mesh Role An AP operating as a mesh node can have one of two roles: mesh portal or mesh point.
Parent If the AP is operating as a mesh point, this parameter displays the name of its parent mesh
portal. Mesh portals will display a dash (-).
#Children If the AP is operating as a mesh portal, this parameter shows the number of mesh point children
associated with that mesh portal.
AP type The AP model type.
Uptime Number of hours, minutes and seconds since the last controller reboot or bootstrap, in the
format hours:minutes:seconds.
Platforms Licensing Command Mode
All platforms This show command is available in the
base operating system. Commands to
configure the secure enterprise mesh
solution for outdoor APs require the
Outdoor Mesh license.
Enable or Config mode on master controllers
Column Description