Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide Introduction | 7
ipv6 firewall The enable parameter has been removed from this command. The ipv6 enable
command is the global command to enable/disable ipv6 processing on the
controller.
mgmt-server secondary-
server <ip-addr>
The secondary-server parameter has been deprecated.
masterip ipsec-custom-
cert| ipsec-factory-cert
Use a custom-installed or factory-installed certificate on the master controller to
establish a master-local IPsec tunnel using IKEv2.
master-redundancy peer-ip
ipsec-factory-cert|ipsec-
custom-cert
The ipsec-factory-cert and ipsec-custom-cert parameters were introduced to
allow certificate-based authentication of master and local controllers.
ntp server [key <key-id>] The key-id parameter authenticate sthe NTP server. This needs to match the key
identifier configured in the ntp authentication-key command.
netdestination This command configures an alias for an IPv4 -only network host, subnetwork, or
range of addresses.
ping Introduced ipv6 parameter to provide support for IPv6.
provision-ap The following new parameters were introduced for provisioning IPv6 APs:
 dns-server-ip6
 ip6addr
 ip6prefix
 gateway6
remote-node-masterip
ipsec-factory-cert
Secure communication between a Remote-Node and Remote-Node master by
identifying a factory-installed certificate on the Remote-Node Master.
remote-node-profile The following parameters were introduced for configuring a remote node profile:
 ipv6
 mgmt-server
 mobility-manager
 snmp-server
 syscontact
 syslocation
The controller-ip parameter has been deprecated.
rf dot11a-radio-profile
<profile> spectrum-
monitoring
Issue this command to turn an AP in ap-mode into a hybrid AP. An AP in hybrid AP
mode serves clients as an access point while it scans and analyzes spectrum
analysis data for a single radio channel. For further details on using hybrid APs and
spectrum monitors to examine the radio frequency (RF) environment in which the
Wi-Fi network is operating, refer to the Spectrum Analysis chapter of the Dell
PowerConnect W-Series ArubaOS 6.1 User Guide.
rf dot11g-radio-profile
<profile> spectrum-
monitoring
Issue this command to turn an AP in ap-mode into a hybrid AP. An AP in hybrid AP
mode serves clients as an access point while it scans and analyzes spectrum
analysis data for a single radio channel. For further details on using hybrid APs and
spectrum monitors to examine the radio frequency (RF) environment in which the
Wi-Fi network is operating, refer to the Spectrum Analysis chapter of the Dell
PowerConnect W-Series ArubaOS 6.1 User Guide.
show aaa state debug-
statistics
The Mobility Stats parameter was introduced.
show ap active The parameter ip6-addr was added to view data for an IPv6 AP.
show ap details The parameter ip6-addr was added to view data for an IPv6 AP.
Command Parameter Description