Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide show arp | 797
show arp
show arp
Description
Show Address Resolution Protocol (ARP) entries for the controller.
Syntax
No parameters
Example
This example shows configured static ARP entries for the controller.
The output of this command includes the following parameters:
Related Commands
Add a static Address Resolution Protocol (ARP) entry using the command show arp.
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
Protocol Protocol using ARP. Although the controller will most often use ARP to translate IP
addresses to Ethernet MAC addresses, ARP may also be used for other protocols, such as
Token Ring, FDDI, or IEEE 802.11, and for IP over ATM.
Address IP address of the device.
Hardware Address MAC address of the device.
Interface Interface used to send ARP requests and replies.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master and local
controllers
(host) #show arp
Protocol Address Hardware Address Interface
Internet 10.3.129.98 00:1A:1E:C0:80:28 vlan1
Internet 10.3.129.253 00:0B:86:42:35:80 vlan1
Internet 10.3.129.250 00:1A:92:45:DB:00 vlan1
Internet 10.3.129.99 00:1A:1E:C0:1C:60 vlan65
Internet 10.3.129.96 00:1A:1E:C0:80:1E vlan65
Internet 10.3.129.254 00:0B:86:02:EE:00 vlan1