Reference Guide

8 | Introduction Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
show crypto-local pki The following new parameters now display output:
 CRL
 Intermediate CA
 OCSPResponderCert
 OCSPSignerCert
 global-ocsp-signer-cert
 rcp
 service-ocsp-responder
show crypto-local isakmp The parameter certificate-group was introduced.
show datapath The crypto counters parameter now displays a number of TKIP/AESCCM/AESGCM
decriptions per priority level along with any counter errors per priority.
The ipv6 filter option is added to the following parameters in the command:
 session
 tunnel
 user
 route-cache
 route
 ip-reassembly
The parameter vlan-mcast has been added to view the datapath VLAN multicast
table entries.
show ip interface brief View IP-related information on all interfaces in summary format.
show ntp servers brief The key-id parameter output displays if configured for this ntp server.
show tunneled-node
[state|database]
This command name has changed from show mux to show tunneled node. A new
parameter, database, was added.
show tunneled-node config This command name has changed from show mux to show tunneled-node config.
The command functionality did not change..
show wms general Added the following display parameterss
adhoc-ap-ageout-interval
persistent-neighbor
event-correlation
event-correlation-quiet-time
Minutes Tick
tunnel-loop-prevention This command name has changed from mux-loop-prevention to
tunnel-loop-prevention. The command functionality did not change.
tunneled-node-address This command name has changed from mux-address to tunneled-node address.
The functionality command did not change.
vrrp The delay option is added to the preempt parameter.
user-role ipv6 session-acl parameter was removed. The session-acl parameter is common
for both IPv4 and IPv6 ACLs.
wlan ssid-profile
<profile>
opmode wpa2-aes-gcm-
128|wpa2-aes-gcm-256
qbss-load-enable local-
probe-req-thresh
The opmode options wpa2-aes-gcm-128 and wpa2-aes-gcm-256 were introduced.
The qbss-load-enable and local-probe-req-thresh options are included.
wlan ht-ssid-profile The allow-weak-encrytion parameter was deprecated.
wms general learn-system-
wired-macs
Added parameter to enable or disable “learning” of wired MACs at the controller.
Command Parameter Description