Reference Guide

890 | show ids general-profile Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
The output of this command includes the following parameters:
Related Commands
Configure IDS General profiles using the command ids general-profile.
Command History
Parameter Description
Stats Update Interval Interval, in seconds, for the AP to update the controller with statistics. This setting takes
effect only if the Dell Mobility Manager is configured. Otherwise, statistics update to the
controller is disabled.
Monitored Device Stats
Update Interval
Time interval, in seconds, for AP to update the switch with stats for monitored devices.
Minimum is 60.
AP Inactivity Timeout Time, in seconds, after which an AP is aged out.
Adhoc (IBSS) AP
Inactivity Timeout
Ad hoc (IBSS) AP inactivity timeout in number of scans.
AP Max Unseen Timeout Ageout time, in seconds, since AP was last seen.
STA Inactivity Timeout Time, in seconds, after which a station is aged out.
STA Max Unseen Timeout Time, in seconds, after which an AP is aged out.
Min Potential AP Beacon
Rate
Minimum beacon rate acceptable from a potential AP, in percentage of the advertised
beacon interval.
Min Potential AP
Monitor Time
Minimum time, in seconds, a potential AP has to be up before it is classified as a real AP.
Signature Quiet Time After a signature match is detected, the time to wait, in seconds, to resume checking.
Wireless Containment Shows if the profile has enabled or disabled containment from the wireless side.
Debug Wireless
Containment
Shows if the profile has enabled or disable debugging of containment from the wireless
side.
Wired Containment Shows if the profile has enabled or disable containment from the wired side.
Wired Containment of
AP’s Adj MACs
Enable/disable wired containment of MACs offset by one from APs BSSID.
Mobility Manager RTLS Shows if RTLS communication with the configured mobility-manager is enabled or
disabled.
IDS Event Generation on
AP
Enable or disable IDS event generation from the AP. Event generation from the AP can be
enabled for syslogs, traps, or both. This does not affect generation of IDS correlated
events on the switch.
Send Adhoc Info to
Controller
Enable or disable sending Adhoc information to the controller from the AP.
Version Description
ArubaOS 3.0 Command Introduced
ArubaOS 5.0 Mobility Manager RTLS parameter introduced
ArubaOS 6.0 Refreshed show output