Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide Introduction | 9
Deprecated Commands
The folowing commands were deprecated in ArubaOS 6.1:
About this Guide
This guide describes the ArubaOS command syntax. The commands in this guide are listed alphabetically.
The following information is provided for each command:
 Command Syntax—The complete syntax of the command.
 Description—A brief description of the command.
 Syntax—A description of the command parameters, including license requirements for specific parameters if
needed. The applicable ranges and default values, if any, are also included.
 Usage Guidelines—Information to help you use the command, including: prerequisites, prohibitions, and
related commands.
 Example—An example of how to use the command.
 Command History—The version of ArubaOS in which the command was first introduced. Modifications and
changes to the command are also noted
 Command Information—This table describes any licensing requirements, command modes and platforms for
which this command is applicable. For more information about available licenses, see the “Software Licenses”
chapter in the Dell PowerConnect W-Series ArubaOS 6.1 User Guide.
Connecting to the Controller
This section describes how to connect to the controller to use the CLI.
wms-local system max-
system-wm | system-wm-
update-interval
Added parameter to set the max number of system wired MAC table entries
learned at the controller and set the interval, in minutes, for repopulating the
system wired MAC table at the controller.
Command Description
show ipv6 access-list
(deprecated)
Displays IPv6 access lists configured in the controller. This command has
been replaced by the show ip access-list command.
show ipv6 datapath session
counters (deprecated)
Displays datapath session table statistics. This command has been
replaced by the show datapath session ipv6 counters command.
show ipv6 datapath session
table (deprecated)
Displays current IPv6 session on the controller. This command has been
replaced by the show datapath session ipv6 table command.
show ipv6 datapath user
counters (deprecated)
Displays datapath user table statistics. This command has been replaced
by the show datapath user ipv6 command.
show ipv6 datapath user table
(deprecated)
Displays ipv6 datapath user table entries. This command has been
replaced by the show datapath user ipv6 command.
Command Parameter Description