Reference Guide

Table Of Contents
928 | show ip access-group Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
show ip access-group
show ip access-group
Description
Display access control lists (ACLs) configured for each port on the controller.
Syntax
No parameters.
Examples
The example below shows part of the output of this command. If a port does not have a defined session ACL, the
Port-Vlan Session ACL table is blank.
The output of this command includes the following parameters:
Related Commands
Command History
Command Information
Parameter Description
Session ACL Name of the ACL applied to the interface.
VLAN If the ACL was applied to a VLAN associated with this port, this column will show the VLAN ID.
Status Shows whether or not the session ACL is configured.
Command Description
interface fastethernet | gigabitethernet ip access-
group
.
Configure an access group for an interface.
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.4 The VLAN output parameters was introduced.
Platforms Licensing Command Mode
All platforms Base operating system Available in Config or Enable mode on master or
local controllers
(host) # show ip access-group
FE 1/0:
Rx access list 200 is applied
session access list User14 is applied
Port-Vlan Session ACL
---------------------
SessionACL Vlan Status
---------- ---- ------
coltrane 22 configured