Users Guide

Dell PowerConnect ArubaOS 5.0 | User Guide Remote Access Points | 159
Using the WebUI
The following procedure illustrates the steps to configure an internal database for a remote AP user. To configure
the user role, you first create a policy that permits the following traffic:
z AP control traffic via the Dell PAPI protocol
z GRE tunnel traffic
z ESP tunnel traffic
z Layer-2 Tunneling Protocol (L2TP) traffic
z TFTP traffic
z FTP traffic
Then, you create a user role that contains this policy.
1. Navigate to the Configuration > Security > Access Control > Policies page.
2. Click Add to create a policy.
3. Enter the Policy Name (for example, rap_policy).
4. From the Policy Type drop-down list, select IPv4 Session.
5. To create the first rule:
f. Under Rules, click Add.
g. For Source, select any.
h. For Destination, select any.
i. For Service, select service, then select svc-papi.
j. Click Add.
6. To create the next rule:
a. Under Rules, click Add.
b. For Source, select any.
c. For Destination, select any.
d. For Service, select service, then select svc-l2tp.
e. Click Add.
7. To create the next rule:
a. Under Rules, click Add.
b. For Source, select any.
c. For Destination, select any.
d. For Service, select service, then select svc-gre.
e. Click Add.
8. To create the next rule:
a. Under Rules, click Add.
b. For Source, select any.
c. For Destination, select any.
d. For Service, select service, then select svc-esp.
e. Click Add.
9. To create the next rule:
a. Under Rules, click Add.
b. For Source, select any.