Reference Guide

1046 | show rf arm-profile Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
This example displays the configuration settings for the profile Wireless_rf_profile.
The output of this command includes the following parameters:
Parameter Description
Assignment Displays the current ARM channel/power assignment mode.
Allowed bands for 40MHz channels Shows if 40 MHz mode of operation is allowed on the 5 GHz (802.11a) or 2.4 GHz (802.11b/g)
frequency band only, on all frequency bands, or on neither frequency band.
Client Aware Shows if the client aware feature is enabled or disabled. When enabled, the AP does not
change channels when there are active clients.
Max Tx Power The highest transmit power levels for the AP, from 0-30 dBm in 3 dBm increments. Higher
power level settings may be constrained by local regulatory requirements and AP
capabilities. In the event that an AP is configured for a Max Tx Power setting it cannot
support, this value will be reduced to the highest supported power setting.
Min Tx Power The lowest transmit power levels for the AP, from 0-30 dBm, in 3 dBm increments. Note that
power settings will not change if the Assignment option is set to disabled or maintain.
Multi Band Scan If enabled, single-radio APs will try to scan across bands for rogue AP detection.
Rogue AP Aware If enabled, Dell APs may change channels to contain off-channel rogue APs with active
clients. This security features allows APs to change channels even if the Client Aware
setting is disabled.
This setting is disabled by default, and should only be enabled in high-security
environments where security requirements are allowed to consume higher levels of
network resources. You may prefer to receive Rogue AP alerts via SNMP traps or syslog
events.
(host) #show rf arm-profile default
Adaptive Radio Management (ARM) profile "test"
----------------------------------------------
Parameter Value
--------- -----
Assignment disable
Allowed bands for 40MHz channels a-only
Client Aware Enabled
Max Tx Power 30 dBm
Min Tx Power 9 dBm
Multi Band Scan Enabled
Rogue AP Aware Disabled
Scan Interval 10 sec
Active Scan Disabled
Scanning Enabled
Scan Time 110 msec
VoIP Aware Scan Disabled
Video Aware Scan Enabled
Power Save Aware Scan Enabled
Ideal Coverage Index 10
Acceptable Coverage Index 4
Free Channel Index 25
Backoff Time 240 sec
Error Rate Threshold 50 %
Error Rate Wait Time 30 sec
Noise Threshold 75 -dBm
Noise Wait Time 120 sec
Minimum Scan Time 8 sec
Load aware Scan Threshold 1250000 Bps