Reference Guide

1204 | show wms routers Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
show wms routers
show wms routers <mac>
Description
Show Learned Router Mac Information for WMS APs.
Syntax
Usage Guidelines
This command displays the MAC addresses of devices that have been determined to be routers by the listed APs.
This output of this command will be blank if there is not any broadcast/multicast activity in an AP's subnet.
Example
In the example below, a single WMS AP has learned MAC information for four different routers.
Command History
This command was introduced in ArubaOS 3.0
Command Information
Column Description
<mac> MAC address of a probe that can see the router.
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
(host) #show wms routers
Router Mac 00:08:00:00:11:12 is Seen by APs
-------------------------------------------
AP-Name
-------
AP32
Router Mac 00:08:00:00:11:29 is Seen by APs
-------------------------------------------
AP-Name
-------
AP32
Router Mac 00:08:00:00:11:57 is Seen by APs
-------------------------------------------
AP-Name
-------
AP32
Router Mac 00:08:00:00:11:6e is Seen by APs
-------------------------------------------
AP-Name
-------
AP32