Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide ap-regroup | 123
ap-regroup
ap-regroup {ap-name <name>|serial-num <num>|wired-mac <macaddr>} <group>
Description
This command moves a specified AP into a group.
Syntax
Usage Guidelines
All APs discovered by the controller are assigned to the “default” AP group. An AP can belong to only one AP
group at a time. You can move an AP to an AP group that you created with the ap-group command.
Example
The following command moves an AP to the ‘corpnet’ group:
(host)(config) #ap-regroup wired-mac 00:0f:1e:11:00:00 corpnet
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Parameter Description Default
ap-name Name of the AP. —
serial-num Serial number of the AP. —
wired-mac MAC address of the AP. —
<group> Name that identifies the AP group. The name must be 1-63 characters. “default”
Note: This command automatically reboots the AP.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master controllers