Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide vpdn group pptp | 1257
vpdn group pptp
vpdn group pptp
client configuration {dns|wins} <ipaddr1> [<ipaddr2>]
disable|enable
no ...
ppp authentication {MSCHAP|MSCHAPv2}
pptp echo <seconds>
Description
This command configures a PPTP VPN connection.
Syntax
Usage Guidelines
PPTP connections require user-level authentication through a PPP authentication protocol (MSHCAPv2 is the
currently-supported method.) Client addresses are assigned from a pool configured with the pptp command.
Example
The following command configures virtual private dial-in networking:
vpdn group pptp
ppp authentication MSCHAPv2
client configuration dns 10.1.1.2
client configuration wins 10.1.1.2
Command History
The command was introduced in ArubaOS 3.0.
Parameter Description Range Default
client configuration Configures parameters for the remote clients. — —
dns Configures a primary and optional secondary
DNS server.
——
wins Configures a primary and optional secondary
WINS server.
——
disable|enable Disables or enables termination of PPTP clients. — enabled
no Negates any configured parameter. — —
ppp authentication Enables the protocols for PPP authentication.
This list should match the PPTP configuration
configured with the vpn-dialer command on the
controller.
——
MSCHAP Use MSCHAP with PPP authentication. — —
MSCHAPv2 Use MSCHAPv2 with PPP authentication. This is
the default for L2TP
——
pptp echo Time, in seconds, that the controller waits for a
PPTP echo response from the client before
considering the client to be down. The client is
disconnected if it does not respond within this
interval.
10-300 60 seconds