Reference Guide

1322 | Appendix A: Command Modes Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
Enable Mode
To move from user mode to enable mode, you must enter the command enable, press Enter, then enter config
mode password that was defined during the controller’s initial setup process. (The default password is enable.)
Users in enable mode may return to user mode at any time by entering the command exit.
The command prompt for a CLI session in enable mode is a pound (#) symbol:
(host) #
The following commands are available in enable mode.
Config Mode
To move from enable mode to config mode, enter the command config terminal. Users in config mode may
return to enable mode at any time by entering the command exit.
When you are in config mode, (config) appears before the # prompt:
(host) (config) #
The following commands are available in basic config mode.
z aaa authentication dot1x clear|
|reload-cert
z aaa authentication stateful-dot1x
clear
z aaa inservice
z aaa ipv6 user add
z aaa ipv6 user clear-sessions
z aaa ipv6 user clear-sessions
z aaa ipv6 user delete
z aaa ipv6 user logout
z aaa query-server
z aaa test-server
z aaa user add
z aaa user clear-sessions
z aaa user delete
z aaa user logout
z am
z ap wipe out flash
z ap-regroup
z ap-rename
z apboot
z apdisconnect
z apflash
z audit-trail
z backup
z boot
z clock
z configure terminal
z copy
z crypto isakmp packet-dump
z crypto pki
z crypto pki-import
z database synchronize
z delete
z dir
z dynamic-ip
z encrypt
z exit
z export
z halt
z help
z license
z localuserdb
z local-userdb-guest
z packet-capture
z page
z paging
z panic
z pcap
z ping
z reload
z reload-peer-sc
z rename
z restore
z rft
z show
z stm
z support
z tar
z traceroute
z usb reclassify
z whoami
z wms ap
z wms clean-db
z wms client
z wms export-class
z wms export-db
z wms import-db
z wms reinit-db
z write