Reference Guide

326 | ip radius Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
ip radius
ip radius {nas-ip <ipaddr>|rfc-3576-server udp-port <port>|source-interface
{loopback|vlan <vlan>}
Description
This command configures global parameters for configured RADIUS servers.
Syntax
Usage Guidelines
This command configures global RADIUS server parameters. If the aaa authentication-server radius command
configures a server-specific NAS IP, the server-specific IP address is used instead.
Example
The following command configures a global NAS IP address sent in RADIUS packets:
(host) (config) #ip radius nas-ip 192.168.1.245
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description Range Default
nas-ip NAS IP address to send in RADIUS packets. A server-specific NAS IP
configured with the aaa authentication-server radius
command supersedes this configuration.
——
rfc-3576-server Configures the UDP port to receive requests from a RADIUS server that
can send user disconnect and change-of-authorization messages, as
described in RFC 3576, “Dynamic Authorization Extensions to Remote Dial
In User Service (RADIUS)”. See the aaa rfc-3576-server command to
configure the server.
NOTE: This parameter can only be used on the master controller.
udp-port UDP port to receive server requests. 0-65535 3799
source-inter
face
Interface for all outgoing RADIUS packets. The IP address of the specified
interface is included in the IP header of RADIUS packets. The interface
can be one of the following:
loopback The loopback interface. — —
vlan The specified VLAN. — —
Platform License Command Mode
Available on all platforms The ip radius rfc-3576-server udp-port command
requires the PEFNG license. Other commands are
available in the base operating system.
Config mode on master and local
controllers