Reference Guide

452 | rf dot11a-radio-profile Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
channel-reuse-
threshold
RX Sensitivity Tuning Based Channel Reuse Threshold, in
- dBm.
If the Rx Sensitivity Tuning Based Channel reuse feature
is set to static mode, this parameter manually sets the
AP’s Rx sensitivity threshold (in -dBm). The AP will filter
out and ignore weak signals that are below the channel
threshold signal strength.
If the value is set to zero, the feature will automatically
determine an appropriate threshold.
Depends on
regulatory
domain
—
clone Name of an existing radio profile from which parameter
values are copied.
——
csa Channel Switch Announcement (CSA), as defined by IEEE
802.11h, allows an AP to announce that it is switching to
a new channel before it begins transmitting on that
channel.
Clients must support CSA in order to track the channel
change without experiencing disruption.
—disabled
csa-count Number of CSA announcements that are sent before the
AP begins transmitting on the new channel.
1-16 4
disable-arm-wids-
function
Disables Adaptive Radio Management (ARM) and
Wireless IDS functions. These can be disabled if a small
increase in packet processing performance is desired. If
a radio is configured to operate in Air Monitor mode, then
these functions are always enabled irrespective of this
option. CAUTION: Use carefully, since this effectively
disables ARM and WIDS
1-16 4
dot11h Enable advertisement of 802.11d (Country Information)
and 802.11h (TPC or Transmit Power Control) capabilities
This parameter is enabled by default.
— enabled
high-throughput-
enable
Enables high-throughput (802.11n) features on a radio
using the 5 GHz frequency band.
— enabled
ht-radio-profile Name of high-throughput radio profile to use for
configuring high-throughput support on the 5 GHz
frequency band. See “rf ht-radio-profile” on page 465.
— “default-a”
maximum-distance Maximum distance between a client and an AP or
between a mesh point and a mesh portal, in meters. This
value is used to derive ACK and CTS timeout times. A
value of 0 specifies default settings for this parameter,
where timeouts are only modified for outdoor mesh
radios which use a distance of 16km.
The upper limit for this parameter varies, depending on
the 20/40 MHz mode for a 5 GHz frequency band radio:
z 20MHz mode: 58km
z 40MHz mode: 27km
Note that if you configure a value above the supported
maximum, the maximum supported value will be used
instead. Values below 600m will use default settings.
0-57km (40MHz
mode)
0-27km
(20MHz mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate limiting management frames
in seconds. Zero disables rate limiting.
Note: This parameter only applies to AUTH and ASSOC/
RE-ASSOC management frames.
0-60 1 second
interval
mgmt-frame-throttle-
limit
Maximum number of management frames allowed in
each throttle interval.
NOTE: This parameter only applies to AUTH and ASSOC/
RE-ASSOC management frames.
0-999999 20 frames per
interval
Parameter Description Range Default