Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show adp config | 565
show adp config
show adp config
Description
Show Dell Discovery Protocol (ADP) configuration settings.
Syntax
No parameters.
Example
The following example shows that the controller has all default settings for ADP.
The output of this command includes the following parameters:
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
discovery Dell APs send out periodic multicast and broadcast queries to locate the master controller.
If the APs are in the same broadcast domain as the master controller and ADP is enabled
on the controller, the controller automatically responds to the APs’ queries with its IP
address.
This command shows whether ADP is enabled or disabled on the controller.
igmp-join Shows whether the controller has enabled or disabled the sending of Internet Group
Management Protocol (IGMP) join requests.
igmp-vlan ID of the VLAN to which IGMP reports are sent. If this value is set to 0, the controller will
use the default route VLAN used.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
(host) #show adp config
ADP Configuration
-----------------
key value
--- -----
discovery enable
igmp-join enable
igmp-vlan 0