Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap active | 567
show ap active
show ap active [ap-name <ap-name>|{arm-edge dot11a|dot11g|voip-
only}|dot11a|dot11g|essid <essid>|ip-addr <ip-addr>|{type access-point|air-
monitor|(sensor dot11a|dot11g|voip-only)}|voip-only
Description
Show all active APs registered to a controller.
Syntax
Example
Issue this command to displays details for all active APs.
The output of this command includes the following information:
Parameter Description
ap-name <ap-name> View data for an AP with a specified name.
arm-edge Show the state of ARM edge APs.
dot11a Show 802.11a radio information.
dot11g Show 802.11g radio information.
voip-only Show AP information filtered by associated/active VoIP clients.
essid <essid> View data for a specific ESSID (Extended Service Set Identifier). An
Extended Service Set Identifier (ESSID) is a alphanumeric name that
uniquely identifies the Service Set Identifier (SSID).
ip-addr <ip-addr> View data for an AP with a specified IP address by entering an IP address in
dotted-decimal format.
type Show AP information filtered by type of AP.
access-point Show information for Access Points only.
air-monitor Show information for Air Monitors only.
sensor Show only RFprotect Sensor information.
voip-only Show AP information filtered by associated/active VoIP clients.
(host)# show ap active
Active AP Table
---------------
Name Group IP Address 11g 11g Ch/EIRP/MaxEIRP 11a 11a Ch/EIRP/MaxEIRP AP
Type Flags Uptime
Clients Clients
---- ----- ---------- ----- ------------------- ------ ---------------- ---
---- ----- ------
AL31 corp1344 10.6.1.202 0 AP:HT:1/8.5/33 0 AP:HT:149+/19/36 125
Column Description
Name Name of an AP
Group The AP is associated with this AP group.