Reference Guide

568 | show ap active Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
Command History
Introduced in ArubaOS 3.0.
Command Information
IP address IP address of the AP, in dotted decimal format.
11g Clients Number of 802.11g clients using the AP.
11g Ch/EIRP/MaxEIRP 802.11g radio channel used by the AP/current effective Isotropic Radiated Power (EIRP) /
maximum EIRP.
11a Clients Number of 802.11a clients using the AP.
11a Ch/EIRP/MaxEIRP 802.11a radio channel used by the AP/current EIRP/maximum EIRP.
AP Type AP model type.
Flags This column displays any flags for this AP. The list of flag abbreviations is also included in the
output of the show ap active command.
z a = Reduce ARP packets in the air
z A = Enet1 in active/standby mode
z B = Battery Boost On
z d = Drop Mcast/Bcast On or Disconnected Sensor
z D = Disconn. Extra Calls On
z E = Wired AP enabled
z K = 802.11K Enabled
z L = Client Balancing Enabled
z M = Mesh
z N = 802.11b protection disabled
z P = PPPOE
z R = Remote AP
z R- = The remote AP requires captive portal authentication. Once this authentication is
successfully completed, the R- flag changes to R.
z S = RFprotect Sensor
z U = USB modem
z X = Maintenance Mode
Uptime Number of hours, minutes and seconds since the last controller reboot or bootstrap, in the
format hours:minutes:seconds.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Column Description