Reference Guide

598 | show ap config Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
Ortronics LED off Time-
out
Automatically turns off the LEDs 5 minutes after the AP boots up.
Ortronics Low Temp The low-temperature threshold for the Ortronics AP. If the temperature reaches this
threshold, the maximum transmit power is restored to four.
Ortronics High Temp The high-temperature threshold for the Ortronics AP. The maximum transmit power range
is 0— 4, with a default of 4. If the AP temperature meets or exceeds this threshold, the
maximum transmit power is reduced by one until it reaches zero.
RTLS Server configuration Displays whether or not the AP will send RFID tag information to an RTLS server.
Remote-AP DHCP Server
VLAN
Shows the VLAN ID of the remote-AP DHCP server used when controller is unreachable.
Remote-AP DHCP Server Id Shows the IP Address of the DHCP DNS Server.
Remote-AP DHCP Default
Router
Shows the IP Address of the DHCP Default Router.
Remote-AP DHCP Pool Start Shows the IP Address used as start of DHCP Pool.
Remote-AP DHCP Pool End Shows the IP Address used as end of DHCP Pool.
Remote-AP DHCP Pool
Netmask
Shows the netmask of DHCP Pool.
Remote-AP DHCP Lease Time Shows the length of leases, in days (0 means infinite).
Heartbeat DSCP DSCP value of AP heartbeats (0-63).
Session ACL Shows the access control list (ACL) applied on the uplink of a remote AP.
Maintenance Mode Shows if Maintenance mode is enabled or disabled. If enabled, APs stop flooding
unnecessary traps and syslog messages to network management systems or network
operations centers when deploying, maintaining, or upgrading the network. The
controller still generates debug syslog messages if debug logging is enabled.
Radio enable Shows if the AP’s radio is enabled or disabled.
Mode Shows the operating modes for the AP.
z ap-mode: Device provides transparent, secure, high-speed data communications
between wireless network devices and the wired LAN.
z am-mode: Device behaves as an air monitor to collect statistics, monitor traffic,
detect intrusions, enforce security policies, balance traffic load, self-heal coverage
gaps, etc.
High throughput enable
(radio)
Shows if high-throughput (802.11n) features on the 2.4 GHz frequency band are enabled
or disabled.
Channel Shows the channel number for the AP’s 802.11a/802.11n physical layer.
Beacon Period Shows the time, in milliseconds, between successive beacon transmissions. The beacon
advertises the AP’s presence, identity, and radio characteristics to wireless clients.
Transmit Power Shows the current transmission power level.
Advertise 802.11d and
802.11h Capabilities
This column reports whether or not the AP will advertise its 802.11d (Country Information)
and 802.11h (TPC or Transmit Power Control) capabilities
Enable CSA Displays whether or not the AP has enabled channel switch announcements (CSAs) for
802.11h.
CSA Count Number of channel switch announcements that must be sent before the AP will switch to
a new channel.
Parameter Description