Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap debug datapath | 627
show ap debug datapath
show ap debug datapath {ap-group <ap-group>|ap-name <ap-name>|bssid <bssid>|ip-addr
<ip-addr>}
Description
Show datapath tunnel parameters of an AP or AP group.
Syntax
Example
The output of the following command shows datapath tunnel parameters for an AP with the IP address
192.0.2.32.
The output of this command includes the following information:
Command History
Introduced in ArubaOS 3.0.
Parameter Description
ap-group <ap-group> Show data path information for a specific AP group.
ap-name <ap-name> Show data path information for an AP with a specific name.
bssid <bssid> Show data path information for a specific Basic Service Set Identifier (BSSID). The Basic
Service Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr> Show data path information for an AP with a specific IP address by entering an IP address in
dotted-decimal format.
(host) #show ap debug datapath 192.0.2.32
Datapath Parameters Table
-------------------------
essid encr-alg client-vlan-id tunnel-id gre-type deny-bcast num-clients
----- -------- -------------- --------- -------- ---------- -----------
guest Open 63 0x10f6 0x8300 disable 0
voip WPA2 8021X AES 66 0x1103 0x8310 disable 7
corpWPA2 PSK AES 66 0x10f1 0x8320 disable 0
guest Open 63 0x10f7 0x8200 disable 1
wpa2 WPA2 8021X AES 65 0x10be 0x8210 enable 15
Column Description
ESSID The Extended Service Set Identifier is a unique name that identifies a wireless network
encr-alg Encryption algorithm used by the network
client-vlan-id ID of the network VLAN
tunnel-id Identification number of the AP’s tunnel.
gre-type GRE tunnel type.
deny-bcast If enabled, the AP will respond to broadcast probe requests. If disabled, the AP will not
respond to these requests.
num-clients Number of clients currently using the network.