Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap debug radio-stats | 635
FIFO Underrun The number of Receive FIFO overruns.
Allocated Desc Number of allocated transmit descriptors.
Freed Desc Number of freed transmit descriptors.
Tx EAPOL Frames Number of Extensible Authentication Protocol over LAN (EAPOL) frames transmitted
Tx AGGR Good Number of aggregated frames successfully transmitted.
Tx AGGR Unaggr Number of non-aggregate frames transmitted due to unavailability of additional
frames for aggregation at the time of transmission.
Tx <number> Mbps Number of frames transmitted at the specified rate (in Mbps).
Tx <number> Mbps
[Long]
Number of frames with a long preamble transmitted at the specified rate.
Tx <number> Mbps
[Short]
Number of frames with a short preamble transmitted at the specified rate.
Tx HT <number> Mbps Number of high-throughput frames transmitted at the specified rate.
Tx WMM Number of Wifi Multimedia (WMM) packets transmitted for the following access categories. If
the AP has not transmitted packets in a category type, this data row will not appear in the
output of the command.
Tx WMM [BE]: Best Effort
Tx WMM [BK]: Background
Tx WMM [VO]: VoIP
Tx WMM [VI]: Video
UAPSD OverflowDrop Number of packets dropped due to Unscheduled Automatic Power Save Delivery (U-APSD)
overflow.
TX Timeouts Number of transmission timeouts
Lost Carrier Events Number of carrier sense timeouts.
Last SNR The last recorded signal-to-noise ratio.
Last SNR CTL0 The signal-to-noise ratio for the last received data packet on the primary (control) channel 0.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR CTL1 The signal-to-noise ratio for the last received data packet on the secondary (control) channel
1. This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR CTL2 The signal-to-noise ratio for the last received data packet on the secondary (control) channel
2. This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR EXT0 Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel 0.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR EXT1 Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel 1.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last SNR EXT2 Signal-to-noise ratio for the last received ACK packet on the secondary (extension) channel 2.
This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR Signal-to-noise ratio for the last received ACK packet.
Last ACK SNR CTL0 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 0. This
parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL1 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 1. This
parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL2 Signal-to-noise ratio for the last received ACK packet on the primary (control) channel 2. This
parameter is only displayed for APs operating in 40 Mhz mode.
Parameter Description