Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide show ap ht-rates | 657
show ap ht-rates
show ap ht-rates bssid <bssid>
Description
Show high-throughput rate information for a basic service set (BSS).
Syntax
Examples
The output of this command shows high-throughput rates for each supported MCS value. These values are
applicable to high-throughput (802.11n-capable) APs only.
The output of this command includes the following information:
Command History
Introduced in ArubaOS 3.3.
Parameter Description
bssid <bssid> Show data for a specific Basic Service Set Identifier (BSSID) on an AP. An AP’s BSSID is
usually the AP’s MAC address.
Column Description
MCS A Modulation Coding Scheme (MCS) values supported on this high-throughput SSID.
Streams Number of spatial streams used by the MCS index value.
20 MHz 802.11n data rates for the MCS for 20 Mhz transmissions.
40 MHz 802.11n data rates for the MCS for 40 Mhz transmissions.
40 MHz SGI 802.11n data rates for the MCS for 40 Mhz transmissions using a short guard interval.
Host) #show ap ht-rates bssid 00:1a:1e:1e:5a:10
AP "AL12" Radio 0 BSSID 00:1a:1e:1e:5a:10 High-throughput Rates (Mbps)
----------------------------------------------------------------------
MCS Streams 20 MHz 40 MHz 40 MHz SGI
--- ------- ------ ------ ----------
0 1 6.5 13.5 15.0
1 1 13.0 27.0 30.0
2 1 19.5 40.5 45.0
3 1 26.0 54.0 60.0
4 1 39.0 81.0 90.0
5 1 52.0 108.0 120.0
6 1 58.5 121.5 135.0
7 1 65.0 135.0 150.0
8 2 13.0 27.0 30.0
9 2 26.0 54.0 60.0
10 2 39.0 81.0 90.0
11 2 52.0 108.0 120.0
12 2 78.0 162.0 180.0
13 2 104.0 216.0 240.0
14 2 117.0 243.0 270.0
15 2 130.0 270.0 300.0