Reference Guide

668 | show ap mesh debug current-cluster Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide
show ap mesh debug current-cluster
show ap mesh debug current-cluster {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-
addr>}
Description
Display information for the mesh cluster currently used by a mesh point or mesh portal.
Syntax
Examples
The output of the command below shows mesh cluster profile configuration parameters for the mesh cluster
currently used by an AP named “mp2.”
The output of this command includes the following information:
Command History
Introduced in ArubaOS 3.0.
Parameter Description
ap-name <ap-name> Show mesh cluster data for an AP with a specific name.
bssid <bssid> Show mesh cluster data for a specific Basic Service Set Identifier (BSSID) on an AP. An AP’s
BSSID is usually the AP’s MAC address.
ip-addr <ip-addr> Show mesh cluster data for an AP with a specific IP address. Enter the IP address in dotted-
decimal format.
Column Description
Cluster Name Name of the mesh cluster using this profile
RF band The RF band in which the mesh point or mesh portal operates:
z g = 2.4 GHz
z a = 5 GHz
Encryption Data encryption setting for the mesh cluster profile.
z opensystem—No authentication and encryption.
z wpa2-psk-aes—WPA2 with AES encryption using a preshared key.
WPA Hexkey The WPA pre-shared key (only for mesh cluster profiles using WPA2 with AES encryption).
WPA Passphrase The WPA password that generates the preshared key (only for mesh cluster profiles using
WPA2 with AES encryption).
(host) #show ap mesh debug current-cluster ap-name mp2
AP "mp2" Current Cluster Profile: default
-----------------------------------------
Item Value
---- -----
Cluster Name smettu-mesh
RF Band a
Encryption opensystem
WPA Hexkey N/A
WPA Passphrase ********